The purpose of carbon black equipment

Carbon black equipmentThe manufacturer stated that the main purpose of the carbon black equipment is to write adhesive wet particles into occupational powders such as food and chemical industries for granulation. What is the purpose of carbon black equipment? I hope you can bring some better help when choosing in the future.

　　The carbon black equipment mainly consists of the body, granulation device, screen tube, gearbox, motor, etc. The body of the carbon black equipment is a separate rectangular body, composed of a base, a bearing frame, and a gearbox. The feed hopper is connected to the bearing frame and extends out of the machine. The body does not need to be installed and can be placed indoors at will; Hinge one end with a nut; Another important point is that both the front and rear of the drum are equipped with bearing brackets located below the hopper. The two ends of the drum adopt symmetrical convex couplings, which are not restricted by inversion and are easy to disassemble. The screen clips are located on both sides of the drum and are made of steel pipes. There is a long groove in the middle of the steel pipe. The gearbox is mainly driven by a worm gear, and the outer end of the worm gear is equipped with an eccentric rod, which is used to drive the gear rod to move back and forth, while the gear shaft that meshes with the gear rod rotates in the opposite direction. Nowadays, high-speed rotation and shearing are mainly used for granulation. The transmission shaft of carbon black equipment is sealed with a large amount of air, which can be replaced with water during cleaning. Fluidized granulation, material is nearly spherical and has good fluidity.

　　Carbon black equipment has a small footprint and low cost; The cost required for the entire granulation process is low; The granulation process is relatively simple and has low energy consumption; Using a sealed environment for treatment, there is no pollution, and the finished product is relatively hygienic. Especially when using carbon black equipment, the granulation time is greatly shortened, and the entire mixing granulation process can be completed in a few minutes. Mixing and cutting can be easily adjusted, suitable for granulation of different raw materials and needs. The manufacturer also adopts PLC human-machine interface control technology during production, which is simple and convenient to control. The operation process is completely enclosed without any pollution. Smooth operation and low noise. Inflatable sealed drive shaft design for easy cleaning. In order to extend its service life, check the parts of the carbon black equipment once a month, mainly including the moving parts of worm gears, worms, bearings, etc., for flexibility and wear. succedaneum; Usually, it should be placed in a dust-free room to avoid the impact of acids, corrosive gases, etc. on the equipment; After use or during shutdown, the drum should be removed, cleaned, and then installed in place.